Numark X9 Guide D'utilisation Rapide page 7

CHANNEL CONTROLS
1. INPUT SELECTOR – Selects the input source to be routed to the corresponding channel.
2. GAIN – Adjusts the channel audio pre-fader and pre-EQ gain level.
3. TREBLE – Adjusts the high (treble) frequencies of the audio playing on the corresponding channel,
4. MID – Adjusts the mid-range frequencies of the audio playing on the corresponding channel.
5. BASS – Adjusts the low (bass) frequencies of the audio playing on the corresponding channel.
6. CUE – Sends pre-fader audio to the Cue Channel for headphone monitoring.
7. CROSSFADER ASSIGN – Routes the audio playing on the corresponding channel to either side of the
crossfader (CFA/CFB), or bypasses the crossfader and sends the audio directly to the Master Mix (OFF).
8. VOLUME – Adjusts the audio level on the corresponding channel.
9. PFL – Monitors the pre-fader audio level on the corresponding channel.
MASTER CONTROLS
10. MASTER – Adjusts the Master output level.
11. BOOTH – Adjusts the Booth output level.
12. PGM – Monitors the Program (Master) mix audio level.
CUE CONTROLS
13. CUE GAIN – Adjusts the level of the headphone audio.
14. CUE BLEND – Turn to mix between Cue and Program in the Headphone channel. When all the way to the left,
only channels routed to CUE will be heard. When all the way right, only the Program mix will be heard.
Push the knob to engage Split Cue mode which sends all audio channels with the CUE Assign button engaged
to the left side of the headphones and the MASTER output to the right side of the headphones. This mode is
an excellent way to mix when booth monitoring is not available.
15. SPLIT – When lit, this LED indicates that Split Cue mode has been enabled. See Cue Blend (#14) for details
on Split Cue mode.
CROSSFADER CONTROLS
16. CROSSFADER – Blends audio between the channels assigned to the left and right side of the crossfader (see
ASSIGN KNOB below).
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then remove
the screws holding it in position. Replace the fader with a quality authorized replacement from your local
Numark retailer only.
17. EQ KILL SWITCHES – Eliminate the bass, mid, or high frequencies of the audio on the corresponding
crossfader channel (CFA/CFB).
MICROPHONE CONTROLS
18. MIC ON / OFF – Mutes and unmutes the microphone signal. When muted, the microphone signal will not be
routed to the Master mix.
19. MIC TREBLE – Adjusts the high (treble) frequencies of the microphone channel.
Tip: If you experience feedback when using a microphone at loud levels, try turning down the high frequencies.
20. MIC BASS – Adjusts the low (bass) frequencies of the microphone channel.
21. MIC GAIN – Adjusts the audio level of the microphone signal.
EFFECTS CONTROLS
22. FX ASSIGN – This knob selects the audio source on which the effects will be applied. You can address
individual mixer channels (1/2/3), either side of the crossfader (CFA/CFB) or you can apply the effect on the
Master mix.
23. FX ON – Turns effects processing on and off. Note that you will also have to raise the Intensity Mix control to
be able to hear the effects once they have been turned on.
24. INTENSITY MIX – Controls the amount of effected (wet) vs. non-effected (dry) sound in the mix. With the fader
down, no effected sound will be audible. With the fader up, only the effected sound will be heard.
7