Rear Panel Features - Numark X9 Guide D'utilisation Rapide

REAR PANEL FEATURES

3
2
1
AC IN – Use the included power adapter to connect the mixer to a power outlet. While the power is
1.
switched off, plug the power supply into the mixer first, then plug the power supply into a power outlet.
Please note: The mixer is designed to work with the included 9V-1.5A AC power supply only. Using
an incompatible power supply could result in damage to the unit.
POWER ADAPTER CABLE CLIP – To prevent accidental unplugging, secure the power adapter cable
2.
to this clip.
POWER SWITCH – Turns the mixer on and off. Turn on the mixer after all input devices have been
3.
connected and before you turn on amplifiers. Turn off amplifiers before you turn off the mixer.
MASTER OUTPUT (BALANCED) – Use balanced ¼" (TRS) cables
4.
to connect this Master output to a speaker or amplifier system. The
level of this output is controlled by the Master knob on the top panel.
Tip: When possible, we recommend using these balanced outputs
for your Master audio output. Balanced outputs are better suited for
long cable runs and are less susceptible to noise and interference.
MASTER OUTPUT (RCA) – Use standard RCA cables to connect this Master output to a speaker or
5.
amplifier system. The level of this output is controlled by the Master knob on the top panel.
BOOTH OUTPUT (RCA) – Use standard RCA cables to connect this Booth output to a booth
6.
monitoring system. The level of this output is controlled by the Booth knob on the top panel.
RECORD OUTPUT (RCA) – Use standard RCA cables to connect this Record output to a recording
7.
device, such as a CD recorder or tape deck. The level of this output is based upon pre-master levels.
LINE | PHONO INPUTS (RCA) – Connect your audio sources to these inputs. These inputs can
8.
accept both line and phono-level signals. See #9 below.
LINE | PHONO SWITCH – Flip this switch to the appropriate position, depending on the device
9.
connected to the Line | Phono inputs (#8). If using phono-level turntables, set this switch to "Phono" to
provide the additional amplification needed for phono-level signals. If using a line-level device, such as
a CD player or sampler, set this switch to "Line".
GROUNDING TERMINAL – If using phono-level turntables with a grounding wire, be sure to connect
10.
the grounding wire to these terminals. If you experience a low "hum" or "buzz", this could mean that
your turntables are not grounded.
Note: Some turntables have the grounding wire built into the RCA connection and, therefore, nothing
needs to be connected to the grounding terminal.
LINE INPUTS – Connect line-level devices, such as CD players, samplers or audio interfaces, to these
11.
inputs.
MIC 2 INPUT – If you would like to use an additional ¼" microphone on Channel 2, connect it to this
12.
input. To route the microphone signal to the mix, you will need to flip the Channel 2 Input Selector
switch, located on the top panel, to "Mic".
FADER START – If you would like to use the mixer's fader-start to automatically start and cue music
13.
from external devices via the mixer crossfader, connect these outputs to your fader-start compatible
device. You can use standard 1/8" stereo cables to make these connections.
13
4
5 6
10
9 9
7
8 11
8
5
10
9
8 11
12
How do I know if my ¼"
cables are balanced?
BALANCED
UNBALANCED