Important Instructions; User Servicing Instructions - Vornado 184 Mode D'emploi

Important Instructions

Your Vornado Air Circulator has a polarized plug. (One blade is wider than the other.) To
reduce the risk of electrical shock, this plug is intended to fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat this safety feature.
WARNING – To reduce the risk of fire or electrical shock, do not use this product with
any solid state speed control device. To reduce the risk of fire or electric shock and
injury to persons, do not use in a window. This product employs overload protection
(fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows,
unplug the product from the outlet. Replace the fuse as per the user servicing
instructions (follow product marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short-circuit may be present and the product should be
discarded or returned to an authorized service facility for examination and/or repair.
Do unplug your Tower Circulator before cleaning.
Do clean your Vornado Tower Circulator regularly.
Refer to the CLEANING instructions provided. Never clean the air circulator in any
manner other than as instructed in this manual.
Do Not use gasoline, thinners, solvents, ammonias or other chemicals for cleaning.
Do Not immerse this product in water or allow water to drip into the motor housing.
Do Not use near furnaces, fireplaces, stoves or other high-temperature heat sources.
Do Not position this product too close to draperies because they may be drawn into
the rear grill, cutting off airflow.
Do Not use this product outdoors.
Do Not use this product on wet surfaces.
Do Not use this product in a bathtub or shower.
Do Not use this product if it has a damaged cord or plug. Discard fan or return to
an authorized service facility for examination and/or repair.
Do Not carry this product by the cord, or use the cord as a handle.
Do Not attempt to repair or replace parts.
Do Not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Arrange cord away from traffic area and where it will not be
tripped over.
Do Not operate the Tower Circulator on an elevated surface, such as a shelf or
desktop, use only while placed on the floor.
Do use common sense when using this product and/or any electrical appliance.
4 English
www.sylvane.com 1-800-934-9194
This product employs overload protection(fuse). A blown fuse indicates an
overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product.
If the replacement fuse blows, a short-circuit may be present and the
product should be discarded or returned to an authorized service facility for
examination and/or repair.
Grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord.
Open fuse cover (A.) by sliding access cover on top of attachment plug
towards blades.
Remove fuse (B.) carefully by gently prying out the ends of the fuse from
the receptacle.
Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse. Contact Vornado
customer service for replacement fuse. Phone: 1-800-234-0604, email:
consumerservice@vornado.com
Install replacement fuse (C.) by first placing the end of the fuse into the fuse
receptacle which is opposite of the blades of the plug, then carefully push
in the other end. Only push against the metal end of the fuse, not the glass
center portion.
Close the fuse access cover (D.) by sliding the cover back into the plug until
it is completely closed, latches and is flush with the face of the plug.
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse,
AFCI, LCDI) that should not be removed. Discard product if the attachment
plug is damaged.
Important Instructions

User Servicing Instructions