Important Safety Instructions; General Safety - Flotec FP0S4100X Notice D'utilisation

Safety

Important Safety Instructions

SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
Save this manual for future reference.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential
for personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided,
could result in death or serious injury.
indicates a hazard which, if not avoided,
could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump .
Keep safety labels in good condition. Replace missing or
damaged safety labels.

General Safety

Risk of electric shock . Can shock, burn or
kill. To reduce the risk of electric shock, use only on
portable self-contained fountains no larger than 5 feet in
any dimension.
1. Pump is designed for use with clean, cold, fresh
water. Do not use to pump any flammable liquid.
2. Do not lift pump by power cord at any time.
Attempting to lift or support the pump by the power
cord can damage the cord and cord connections,
and will void warranty. Always lift the pump by the
lifting handle.
3. Meet National Electri cal Code, Canadian Elec-
tri cal Code, and local codes for all wiring. The
National Electric Code requires installation of a
ground fault circuit interrupter (GFCI) in the branch
circuit supplying fountain pumps and other pond
equipment. Purchase a GFI at your local electrical
supply dealer.
4. Installation must comply with all local codes
pertaining to outdoor ponds/waterfall/fountains.
5. Know the pump application, limitations, and
potential hazards.
6. Disconnect the power before servicing.
For parts or assistance, call Flotec Customer Service at 1-800-365-6832.
7. Release all pressure within the system before
servicing any component.
8. Drain all water from the system before servicing.
9. Secure the discharge line before starting pump. An
unsecured discharge line will whip, possibly causing
personal injury and/or property damage.
10. Check hoses for weak or worn condition before each
use, making certain that all connections are secure.
11. Periodically inspect the pump and system
components. Keep the screen free of debris and
foreign objects. Perform routine maintenance
as required.
12. Personal Safety:
a. Wear safety glasses at all times when working
with pumps.
b. Keep work area clean, uncluttered and
properly lighted – replace all unused tools
and equipment.
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks,
master switches, and by removing starter keys.
13. This equipment is only for use on 115 volt
(single phase) and is equipped with an approved
3-conductor cord and 3-prong, grounding-type plug .
Risk of electric shock . Can shock,
burn or kill. To reduce risk of electric shock, pull
plug before servicing. This pump has not been
investigated for use in swimming pool areas. Pump is
supplied with a grounding conductor and grounding-
type attachment plug. Be sure it is connected only
to an individual branch circuit with a properly
grounded grounding-type receptacle.
Where a 2-prong wall receptacle is encountered, it
must be replaced with a properly grounded 3-prong
receptacle installed in accordance with codes and
ordinances that apply.
14. Make certain power source conforms to requirements
of your equipment.
15. Protect the electrical cord from sharp objects,
hot surfaces, oil, and chemicals. Avoid kinking
cord. Replace or repair damaged or worn
cords immediately.
16. Do not touch an operating motor. Modern motors
are designed to operate at high temperatures.
17. Do not handle pump or pump motor with wet
hands or when standing on wet or damp surface, or
in water.
2