Assembling The Appliance; Cleaning, Maintenance And Ordering Of Spare Parts - Vacmaster EAT718S Mode D'emploi D'origine

5.1 Assembling The Appliance

Fitting The Appliance Head (Fig. 2)
● The appliance head (3) is fastened to the container (7) by the locking hook (6). To remove the
appliance head (3), open the locking hook (6) and remove the appliance head (3). When fitting
the appliance head (3), make sure that the locking hook (6) locks into place correctly.
● Plug the vacuum tube (9) onto the end of the suction hose (10).
● Fit the suction hose (10) onto the connection (8) and turn until securely attached.
5.2 Fitting The Filter
IMPORTANT!
Never use the ash vacuum without the filter!
Always ensure that the filters are perfectly secure.
Dismantling/Assembly of the filter (Fig. 6-8)
Turn the filter cage (4) to the left and remove it from the appliance head (3). Next, remove the filter
cartridge for fine ash dust (11). Now remove the foam filter (12).
IMPORTANT!
If there is no filter cartridge for fine ash dust (11) mounted on the appliance head (3), the ash filter
cannot be switched on. The equipment comes with a switch (z) which allows operation only when it is
pressed and when a filter cartridge is fitted (Fig. 10).
6. OPERATION
6.1 On/off Switch (Fig. 1/2)
Press the ON/OFF switch (2) to switch the equipment ON and OFF.
6.2 Filling Level Indicator (Fig. 1/9)
The ash vacuum is fitted with a filling level indicator (5) . If the filling level indicator (5) shows a red bar,
tank contents and filter should be emptied or cleaned.
The red bar indicates severe soiling of the filter; this can also be when the tank is not yet full. You must
then tap on the filter to clear it again.
IMPORTANT!
The ash vacuum cleaner is not suitable for the vacuuming of combustible materials!

7. CLEANING, MAINTENANCE AND ORDERING OF SPARE PARTS

IMPORTANT!
Always pull out the mains power plug before starting any cleaning work.
23