Connecting Wires To Terminals - Kenwood KTC-HR100 Mode D'emploi

Connecting Wires to Terminals

■ If you want to connect the Control unit
Control unit
Connection wire
(Accessory1)
To control unit
(Front side)
(Rear side)
Disc changer, etc.
To KENWOOD disc changer/
External optional accessory
To connect these leads, refer to the
relevant instruction manuals.
To KENWOOD disc changer/
HD Radio control input
HD Radio tuner
— 8 —
When connecting multiple units (such as the CD
Changer and KCA-S210A), connect the KTC-HR100
directly to the control unit.
FM/AM antenna
Antenna cable
(Accessory6)
When the control unit is connected, you cannot use this
"TO CONTROLLER" input terminal.
When you use Controller unit (optional accessory), refer
to <If you want to connect the Controller> of the next
page and connect Controller unit.