Connecting Wires To Terminals; Control Unit - Kenwood KTC-HR100TR Mode D'emploi

Connecting Wires to Terminals

■ If you want to connect the Control unit
• When you use Controller unit (optional accessory), refer to <If you want to connect the Controller> of the next page
and connect Controller unit.

Control unit

Connection wire (Accessory1)
To control unit
(Front side)
(Rear side)
Disc changer, etc.
To Kenwood disc changer/ External
optional accessory
• To connect these leads, refer to the relevant
instruction manuals.
To Kenwood disc changer/
HD Radio control input
• When connecting multiple units (such as the CD Changer and KCA-
S210A), connect the KTC-HR100TR/ KTC-HR100MC directly to the
control unit.
HD Radio tuner
Antenna cable
(Accessory6)
• When the control unit is connected, you cannot
use this "TO CONTROLLER" input terminal.
FM/AM antenna
11
|
English