Preset Tuning; Switching Display; Text Scroll; In Hd Radio Source - Kenwood KTC-HR100 Mode D'emploi

Operations

Preset Tuning

Calling up the stations in the memory.
1
Select the band
Press the [FM] or [AM] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are displayed above
the [1] — [6] buttons. (KDC-X969/KDC-X869/KDC-MP922)
Repeatedly press the button until the function item is not
displayed above the [2] — [5] button. (KDC-MP822/KDC-
V7022/KDC-X769/KDC-722)
3
Call up the station
Press the desired [1] — [6] button.
When the preset broadcast station is transmitting either an analog
broadcast or a digital broadcast, the sound will not be output unless
the broadcast mode matches the setting of <Receive Mode>.

Switching Display

When you are listening to the HD Radio, you can switch over the
display information as follows.
For operations, see the <Switching Display> page of the
instruction manual of your control unit.
What is displayed may partly depend on control units to be
connected.
HD Radio mode
Information
Station Name
Song title/Artist name/Album name/Genre
Receive Frequency

Text Scroll

Setting the displayed text scroll.
In HD Radio source (Function of remote)
[FM]/ [AM] buttons
[4]/ [¢] buttons
[0] — [9] buttons
Display
"Station Name"/"NAME"
"Title"/"TITLE"
"Frequency"/
— 6 —
•
Displayed information except "Frequency" are shown only when
you receive text in digital broadcasting. If text cannot be displayed,
frequency will be shown.
• Though some models have two lines in the display, you cannot
display the same information in both the Upper Part and the
Lower Part.
For operations, see the <Text Scroll> page of the instruction
manual of your control unit.
Select the band.
Each time the [FM] button is pressed it switches between the
HF1, HF2, and HF3 bands.
Press the [AM] button to select the HA band.
Tune up or down band.
Press buttons [1] — [6] to recall preset stations.