Functions In The Main Menu - schmalz VS-VP1-W-D NPN K 3C-D Manuel D'utilisation Simplifié

Activating the Main Menu and Selecting Parameters
ü The Vacuum/pressure switch is in Measurement mode.
1. Press the
The first parameter in the main menu is selected. This is indicated by ot1 in
ð
the lower display.
2. Press the
output.
3. By pressing the
parameter value is accepted.
6.3 Functions in the Main Menu
The following table shows an overview of the display codes and parameters in the main
menu:
Parameter
OUT1 output
operating mode
OUT1 output
Switching logic
OUT2 output
operating mode
This selection will not be
displayed if only one out-
put is available.
16 / 44
button for at least three seconds.
or button to select the desired function mode for the OUT1
button, the next parameter is selected and the selected or set
Display code
for the lower
display
ot1
ot2
Display code Explanation
for the main
display
oP5
One point set mode
XY5
Hysteresis mode
Window Comparator
mode
no
"normally open" NO
mode
nC
"normally open" NC
mode
oFF
Output 2 deactivated
oP5
One point set mode
XY5
Hysteresis mode
EN-US · 30.30.01.02016 · 00 · 04/19