Controls And Functions - JB Systems T2 Mode D'emploi

ENGLISH

CONTROLS AND FUNCTIONS

1. START / STOP BUTTONS: Press one of these buttons to start or stop the platter.
2. PLATTER: The platter is equipped with a slip mat. This makes it easier to
manipulate the record for scratch performances.
3. MOTOR OFF BUTTON: Normally the platter stops while you press the start/stop
button (1). In this case the platter stops quite fast due to the electronic brake.
Press the "motor off" button if you want the platter to slow down more smoothly. As
long as the motor is switched off, the led of the button flashes. Press the button
again to switch the motor back on.
4. TARGET LIGHT: White led target light used to locate the exact place on your
record when used in a dark place.
5. SPEED SELECT BUTTONS: Used to select the desired speed.
• Press the "33" button to select the 33rpm speed.
• Press the "45" button to select the 45rpm speed.
6. REVERSE BUTTON: Press this button to reverse the platter rotation, press this
button again to end the reverse mode.
7. PITCH SLIDER: Use the pitch slider to change the actual speed of the platter.
When the slider is in its middle position, the blue led next to the pitch slider will turn
on to indicate that the turntable is locked to the exact center speed.
8. 45RPM ADAPTER: Place this adapter on the platter for playing 7" records with
large center holes.
9. POWER ON/OFF SWITCH: Used to turn the turntable on an off.
10. POWER CORD CONNECTOR: Used to connect to the mains, using the supplied
power cord.
JB SYSTEMS 3/25
OPERATION MANUAL
T2 TURNTABLE