Fanox SIL A Manuel D'utilisation page 290

FILL OUT THE FOLLOWING ITEMS FOR SLAVE DEVICES ONLY:
Reports Binary Input Change Events when
no specific variation requested:
 Never
 Only time-tagged
 Only non-time-tagged
 Configurable to send both, one or
the
other (attach explanation)
Sends Unsolicited Responses:
 Never
 Configurable
 Only certain objects (Class 1)
 Sometimes (attach explanation)
 ENABLE/DISABLE UNSOLICITED
Function codes supported
Default Counter Object/Variation:
 No Counters Reported
 Configurable (attach explanation)
 Default Object ____________
Default Variation ____________
 Point-by-point list attached
Sends Multi-Fragment Responses:
QUICK REFERENCE FOR DNP3.0 LEVEL 2 FUNCTION CODES & QUALIFIERS
Function Codes
1 Read
2 Write
3 Select
4 Operate
5 Direct Operate
6 Direct Operate-No ACK
13 Cold Start
14 Warm Start
20 Enable Unsol. Messages
21 Disable Unsol. Messages
23 Delay Measurement
129 Response
130 Unsolicited Message
www.fanox.com
Reports
Events when no specific variation requested:
 Never
 Binary Input Change With Time
 Binary Input Change With Relative Time
 Configurable (attach explanation)
Sends Static Data in Unsolicited Responses:
 Never
 When Device Restarts
 When Status Flags Change
Counters Roll Over at:
 No Counters Reported
 Configurable (attach explanation)
 16 Bits
 32 Bits
 Other Value _____________
 Point-by-point list attached
OUI
7 6 5
Index Size
Index Size
0- No Index, Packed
1- 1 byte Index
2- 2 byte Index
3- 4 byte Index
4- 1 byte Object Size
5- 2 byte Object Size
6- 4 byte Object Size
Rev.19
time-tagged Binary Input
No other options are permitted.
 No
4 3 2 1
Qualifier Code
Qualifier Code
0- 8-Bit Start and Stop Indices
1- 16-Bit Start and Stop Indices
2- 32-Bit Start and Stop Indices
3- 8-Bit Absolute address Ident.
4- 16-Bit Absolute address Ident.
5- 32-Bit Absolute address Ident.
6- No Range Field (all)
7- 8-Bit Quantity
8- 16-Bit Quantity
9- 32-Bit Quantity
11-(0xB) Variable array
290/301
Change
0