Safety Instructions - Victron energy Phoenix Inverter 12/250 Manuel

1. Safety instructions

WARNING: ELECTRIC SHOCK HAZARD
The product is used in conjunction with a permanent energy source (battery). Input
and/or output terminals may still be dangerously energized, even when the equipment
is switched off. Always disconnect the battery before carrying out maintenance or
servicing the product.
The product has no internal user-serviceable components. Do not remove the front
plate or operate the product if any panels have been removed. All servicing must be
undertaken by qualified personnel.
Please read the installation instructions in the installation manual before installing the
equipment.
This is a Safety Class I product (supplied with a protective grounding terminal). The
chassis must be grounded. A grounding point is located on the outside of the product.
Whenever it is likely that the grounding protection has been damaged, the product
must be turned off and secured against unintended operation; please contact qualified
service staff.
The AC output is isolated from the DC input and the chassis. Local regulations may
require a true neutral. In this case one of the AC output wires must be connected to
the chassis, and the chassis must be connected to a reliable ground. Please note
that a true neutral is needed to ensure correct operation of an earth leakage circuit
breaker.
Ensure that the equipment is used under the correct ambient conditions.
Never operate the product in a wet or dusty environment.
Never use the product where there is a risk of gas or dust explosions.
Ensure there is adequate free space (10 cm) for ventilation around the product and
check that the ventilation vents are not blocked.
1