Safety Instructions And Hazard Warnings - VOLTCRAFT PS-1305-230 Notice D'emploi

Safety Instructions and Hazard Warnings

The guarantee/warranty will be void if damage is incurred resulting from non-compliance
with the operating instructions. We do not accept liability for damage to property or perso-
nal injury caused by misuse or non-compliance with the safety instructions!
This device left the factory in a safe and perfect condition.
We kindly request that you as a user observe the safety instructions and warnings contained in this
operating manual to preserve this condition and to ensure safe operation! Please pay attention to the
following symbols:
An exclamation mark in a triangle indicates important information in these operating
instructions which are to be followed strictly.
The lightning symbol in a triangle warns against an electric shock or the impairment of the
electrical safety of the appliance.
The "hand" symbol indicates special information and advice on operation of the device.
Only for use in dry interior environments
This product has been CE-tested and meets the necessary European guidelines.
°
Grounding wire connection; this screw may not be loosened.
Earth potential, ground potential
Electrical appliances and accessories are no toys and have no place in the hands of children.
On industrial sites, the accident prevention regulations of the association of the industrial workers'
society for electrical equipment and utilities must be followed.
Power units used at schools, training facilities, do-it-yourself and hobby workshops should not be
handled unless supervised by trained, responsible personnel.
Please make sure that your hands, your shoes, your clothing, the floor and the power unit are dry.
Live components may be exposed if covers are opened or parts are removed unless this can be done
by hand.
Before opening it, disconnect the device from all voltage sources.
Capacitors inside the device may still be charged, even if the device has been disconnected from all
voltage sources.
Do not switch the laboratory power unit on immediately after it has been taken from a cold to a warm
environment. Under adverse conditions, the resulting condensation could destroy the device. Allow the
device to reach room temperature before switching it on.
18