Menu 01 - Chrono Setting - Cola DOMUSFIRE C17 Manuel D'installation, D'utilisation Et D'entretien

4.6.1 Menu 01 – Chrono setting
Allows all chronothermostat functions to be enabled/disabled;
select ON to activate the function and display the
relevant segment/LED [ D ]
When Daily, Weekly or
Week End programming is entered, the
appropriate segment/LED [ C ] appears in the top right of the display.
Regarding selections and entering times,
use the buttons according to the table in par. 4.2.
By accessing the submenu:
chronothermostat functions can be enabled/disabled and set.
It is possible to set two operation stages delimited by the
times set according to the following table where the setting
OFF tells the clock to ignore the command.
selection meaning
START1 activation time
STOP1 deactivation time
START2 activation time
STOP2 deactivation time
By accessing the submenu:
enable/disable and set the weekly chronothermostat functions.
The weekly programmer has 4 independent programs whose final
effect consists of a combination of the
4 programmings.
The weekly programmer can be activated or deactivated;
also, by setting OFF in the time field, the clock ignores the
corresponding command.
Carry out programming making sure not to overlap the
hours of activation and/or deactivation on the same day
in different programs.
By accessing the submenu:
possible to enable/disable and set the week-end (Saturday -
Sunday) chronothermostat functions.
Activate WEEK-END programming only
after deactivating the weekly programming.
To avoid unwanted startup and shutdown operations, only
activate one program at a time.
Deactivate the daily program if the weekly program is
required; with this setting it is advisable to deactivate the
week-end program.
DAY PROGRAM,
possible values
time - OFF
time - OFF
time - OFF
time - OFF
WEEK PROGRAM
it is possible to
WEEK-END PROGRAM
the daily
it is
57
D
C
Menu level
Input
Dialogue box
Input
Dialogue box
Menu level
DOMUSFIRE C17-C24
A