English - Philips Azur Elite GC5030 Série Mode D'emploi

Problem Possible cause
You have not closed the
water tank lid properly.
You have not insert
the Quick Calc Release
collector properly back
to the appliance (specific
types only).
You have put a chemical
into the water tank.
The iron does not You have used the steam
produce a steam boost function too often
boost within a short period.
You are ironing before the
iron gets ready
Dirty water Hard water with impurities
and impurities or chemicals has formed
come out of the flakes inside the soleplate.
soleplate during
ironing.
There is an amber The Calc-Clean reminder
light flashing on light is activated. This is
the handle of the to remind you to perform
iron. Calc-Clean.
The iron leaves a The surface to be ironed
shine or an imprint was uneven, for instance
on the garment. because you ironed over
a seam or a fold in the
garment.
The iron makes a There is no water in the
lot of noise. appliance.
Solution
Press the lid until you hear a 'click' .
Stop ironing and let the iron cools down for at
least 1 hour. Take out the Quick Calc Release
collector. Insert it back into the appliance and
ensure the collector is in-line with the surface
of the appliance. Push down the lever ("click").
If the Quick Calc release tray is damaged,
contact a consumer care center in your country
(see the world wide guarantee leaflet for
contact details).
Rinse the water tank and do not put any
perfume or chemicals into the water tank.
Continue ironing in horizontal position and
wait a while before you use the steam boost
function again.
Wait until the iron is ready (the light on the
display panel stops flashing).
Perform Quick Calc Release (specific types
only) or Calc-Clean (specific types only).
See chapter "Cleaning and maintenance".
Perform Quick Calc Release (specific types
only) or Calc-Clean (specific types only).
See chapter "Cleaning and maintenance".
The iron is safe to use on all ironable garments.
The shine or imprint is not permanent and
disappears when you wash the garment. Avoid
ironing over seams or folds. You can also place
a cotton cloth over the area to be ironed to
avoid imprints.
Fill the water in the water tank.

ENGLISH

11