Technical Specifications; Maintenance And Repair - Toolland VL 3001 Mode D'emploi

VL 3001

TECHNICAL SPECIFICATIONS

Mains voltage
Mains frequency
Power input
Power output
Rated current
Motor speed
Thermal protector
Protection degree
Motor working mode
Power cable
Machine dimension
Oil capacity
Max splitting force
Max splitting length
Max splitting diameter
Hydraulic pressure
Cylinder diameter
Feed time
Retract time
Max cylinder stroke
Noise emission stroke dB(A)
Vibration of control
Handle
Attitude
Temperature
Humidity
Transportation and
Storage temperature
Weight

MAINTENANCE AND REPAIR

Ensure the power cable is unplugged

while performing any maintenance and
repair.
The hydraulic system is preset at the

factory. Don't adjust the valve.
Never alter this machine in any manner

under any circumstances. Any alteration
circumventing the design capabilities and
capacities of this machine could result in
serious injury and will void the warranty.
Replace all damaged and worn parts

immediately with original equipment
manufacturers parts only.
After each seasons use, change the

hydraulic oil.
Disconnect the control handle bar from its

linkage part and take off the cushions
from front frame.
www.toolland.eu
230V
50Hz
1500W
2200W
8.5A
2800RPM
130°C
IP.54
40S6%
3G1.0mm²
97x28x46
3,2L
5 ton
520mm
250mm
20Mpa
27,5mm
10S
4S
520mm
< 75
< 2,5m/s²
< 1000M
5-40°C
40°C-< 50%
20°C-< 90%
-25°C/+50°C
41kg
Lift the towing handle and keep the tank

in vertical position.
Disconnect the vent plug and dipstick

from the front cylinder cover.
Put the front frame of the unit in some

container raise the wheels 5cm off the
ground on blocks, and drain the hydraulic
tank.
Deposit the hydraulic fluid for refilling or

change new hydraulic oil (dexrom III
automatic transmission fluid or 10W AW
hydraulic fluid.
Refill the tank within range marked on

the dipstick.
After refilling, insert and tighten the vent

plug and dipstick.
The wedge becomes dull or nicked, it can

be sharpened. Wear safety gloves while
handling the wedge.
The troubles of hydraulic system and

motor other than described above should
only be handled by qualified specialists.
If the motor is overload for a long time,

the thermal protector in it which
operating temperature is 130°C will
disconnect the power of the motor. It's
necessary for you to call your dealer for
customer support.
STORAGE
Store this unit switched off and

unplugged.
Allow machine to cool 5 minutes after

every use before storing.
Protect power supply cable from heat,

sunshine, aggressive liquids and sharp
edges.
Store unit in a clean, dry area. Don't

store it unprotected outdoors, next to
corrosive materials or in damp
environment.
Store this splitter where children can't

start it.
GUARANTEE
Refer to the enclosed guarantee conditions
for the terms and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
English
26