Safety Instructions - Toolland VL 3001 Mode D'emploi

VL 3001
LOG SPLITTER
VL 3001
IMPORTANT MESSAGE
Before operating the log splitter, the bleed
screw (FIG.B, n°13) should be loosened by
some rotations until air can go in and out of
the oil tank smoothly. Air flow thru the bleed
screw hole should be detectable during the
log splitter is under operations. Before
moving the log splitter, make sure the bleed
screw is tightened to avoid oil leaking from
this point. Failed to loosen the bleed screw
will keep the sealed air in hydraulic system
being compressed after being decompressed.
Such continuous air compression and
decompression will blow out the seals of the
hydraulic system and cause permanent
damage to the log splitter.
WARNING
Read this manual carefully before using the
appliance for your own safety.

SAFETY INSTRUCTIONS

When using the appliance always observe the
enclosed safety instruction as well as the
additional safety instructions. The following
symbols are used throughout this manual:
Read the manual carefully.
Wear safety gloves.
Wear safety shoes or heavy
boots.
Wear a protection mask.
Don't touch the rotating mask.
Allow only one person to operate
this machine, keep bystanders
away.
Tools in motion.
www.toolland.eu
Be careful not to prick your
hands.
Don't clean the wedge
barehanded.
Maintenance, installation,
adjustement and cleaning of the
machine only once the power
supply is disconnected according
Operate this machine according
to the arrows.
DIAGRAM ELEKTRISCH CIRCUIT
DIAGRAM HYDRAULISCH CIRCUIT
English
22