Toolland VL 3001 Mode D'emploi page 24

VL 3001
part that is damaged should be properly
repaired or replaced by an authorized
service center unless otherwise indicated
elsewhere in the instruction manual. Do
not use tool if switch does not turn it on
and off.
WARNING! The use of any other

accessory or attachment other than
recommended in the instruction manual
may present a risk of personal injury.
Have your tool repaired by an expert.

This electric appliance is built in
accordance with the relevant safety rules.
Repair of electric appliances must only be
carried out by experts otherwise it may
cause considerable danger for the user.
OPERATING INSTRUCTIONS FOR LOG
SPLITTER
This machine is only intended to split

firewood as detailed in instructions, not
for any other purpose.
Danger, this machine was built to be

operated according to the safety
instructions in this manual.
As with any type of power equipment,

carelessness or error on the part of
operator could endanger the personal
safety and/or property of yourself and
others. It can result in serious injury or
death, such as amputating hands or feet,
throwing objects and other unforeseeable
damage.
Read and follow all instructions before

initial operation.
The manufacturer isn't liable for any

damages by disregard of the instructions.
ASSEMBLING THE LOG SPLITTER
Cut and remove straps bound to the

carton and unpack the carton.
Remove the loose parts included with unit

(i.e. operator's manual, parts assembly).
Set the foams aside.

Connect control handle bar.

Dispose of the packing in an

environmentally friendly manner. Take to
a proper collecting point.
If you notice transport damage while

unpacking, notify your supplier
immediately. Don't operate the machine.
www.toolland.eu
Read, understand and follow all safety

instructions in this manual and labels on
the equipment carefully.
Keep the manual in a safe place for

future and regular reference.
Ensure the machine is disconnected from

power supply while assembling.
PREPARATION BEFORE OPERATING
Put the machine on the level surface of a

sturdy workbench 60cm high.
Check all nuts, bolts and hydraulic fittings

are tights to be sure the equipment is in
safe working condition.
The power supply for this splitter must

have the protection device of under-
voltage, over-voltage, circuit breaker with
a residual current device with maximum
residual current rated at 0,03mA.
Check all safe shields to be sure they are

in the proper position.
Wear non-slip safety shoes, safety

goggles, safety gloves and suitable work
clothing. Never wear jewelry, necktie or
other loose clothing.
Logs should be cut with square ends and

permissible dimensions in advance.
Uneven log (knotted, curved, etc.) should
be cut short.
Make sure the power cable is unplugged

while adjusting.
After adjusting take away the accessories

on or around the unit before switching
on.
Ensure the motor is properly earthed or

apply protection device.
Use only rubber-jacketed cable of

sufficient lead cross section as extensible
cable.
Keep away from inflammable liquids of

gases before starting the machine.
Keep handles free of oil, grease and

resin.
WARNING! Before operating the log splitter,
the bleed screw (FIG.B, n°13) should be
loosened by some rotations until air can go in
and out of the oil tank smoothly. Air flow thru
the bleed screw hole should be detectable
during the log splitter is under operations.
Before moving the log splitter, make sure the
bleed screw is tightened to avoid oil leaking
from this point. Failed to loosen the bleed
English
24