Table des Matières
Publicité
Guidance and manufacturer's declaration – ELECTROMAGNETIC IMMUNITY –
FOR EQUIPMENT AND SYSTEMS THAT ARE NOT LIFE-SUPPORTING
MIO-IONOTENS is intended for use in the electromagnetic environment specified
below. The customer or the user of the device should assure that it is used in such
an environment.
a)
Field strengths from fixed RF transmitters, such as base stations for radio
(cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio
broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess
the electromagnetic environment due to fixed RF transmitters, an electromagnetic site
survey should be considered. If the measured field strength in the location in which MIO-
IONOTENS is used exceeds the applicable RF compliance level above, MIO-IONOTENS
should be observed to verify normal operation. If abnormal performance is observed,
additional measures may be necessary, such as re-orienting or relocating MIO-
IONOTENS.
b)
Over the frequency range 150kHz to 80MHz, field strengths should be less than 3V/m.
Recommended separation distances between portable and mobile RF
communications equipment for MIO-IONOTENS that are not life-supporting
MIO-IONOTENS is intended for use in an electromagnetic environment in which
radiated RF disturbances are controlled. The customer or the user of MIO-IONOTENS
can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and
MIO-IONOTENS as recommended below, according to the maximum output power
of the communications equipment.
Rated maximum
output power of
transmitter
(W)
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in metres (m) can be determined using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmitter
in watts (W) according to the transmitter manufacturer.
Note
1)
At 80 MHz and 800 MHz the separation distance for the higher frequency range applies.
2)
These guidelines may not apply in all situations. Electromagnetic propagation is affected
by absorption and reflection from structures, objects and people.
MIO-IONOTENS. Tous droits réservés. MIO-IONOTENS et le logo
propriété exclusive d'I.A.C.E.R. Srl et sont enregistrés.
MNPG170-07 du 10/08/2020
Édition :
IACER Srl
Separation distance according to the frequency of the
from 150kHz
to 800 MHz
0.12
0.38
1.2
3.8
12
47
from 80MHz
transmitter (m)
to 800 MHz
0.12
0.38
1.2
3.8
12
from 800MHz
to 2,7GHz
0.23
0.73
2.3
7.3
23
sont la
MNPG170-07
Publicité
Table des Matières
