Velleman-Kit K3512 Mode D'emploi page 7

Connecting the starter interrupter:
The starter interrupter can be connected in a number of ways.
1- By interrupting the ignition or the fuel pump:
Ignition lock
Ignition coil, diesel or petrol pump
2- By interrupting starter motor using the relays supplied
Ignition lock
Starter motor or
contact relay
NOTE: If a starter interrupter is not going to be used, then at least one of the two "cnt"
inputs must be connected after the contact
Connecting the ventilator sensor:
If the vehicle ventilator can be switched in after the vehicle has been left, and if the voltage
drop detector is active, then it is recommended to connect the ventilator to the car alarm. It is
possible for the ventilator to be connected to either the positive or negative voltage for
battery
ACC
1
CONTACT
2
3
START
Interrupt cable
+
battery
ACC
1
CONTACT
2
START
3
Interrupt cable
M
Red
86
87
30 brown
85
Yellow
Vi
GD
Ri
Li
C1
C2
2xyellow
DL
WA
S-
S+
So
FN
Vi
GD
Ri
Li
Yellow
C1
C2
DL
Blue
WA
S-
S+
So
FN
7