Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Operating the remote control: (right hand button if there are 2)
1. Press the button once = alarm activate/deactivate with beep signal.
2. Keep the button pressed in = alarm activate/deactivate without beep signal. (If there is
interference from incident light it is possible that with the IR remote control will not work).
3. Press again within 5 seconds of the alarm being activated = warning sensor(s) switched
out (a beep will be heard as confirmation).
NOTE:
•
Five seconds must be waited between switching the alarm IN and switching it OUT.
•
The alarm only becomes active after 5 seconds of being switched on.
•
If the alarm is to be switched out while the siren is sounding, then it is best to keep button
pressed down on the remote control transmitter unit.
Operation of the dashboard LED:
•
Out: alarm out
•
Slow flash: alarm on.
•
Rapid flash: automatic reset of alarm after switching alarm out, ie there are 60 seconds
available to get in and/or start ignition.
Audio and visual signals:
2 x flashes and sound: = alarm on
1 x flash and sound: = alarm off
4 x flashes and sound: alarm off and has been triggered
OVERVIEW OF OPERATION AND INDICATORS
Function
activate
Dashboard
Flashing
LED
Interior siren
2 x beep
Hazard
2 x flash
lights
Start
not possible
Siren/
Pager
Central
locked
locking
K4400
module
Diagnostic function:
12
deactivate
Rapid
flash
1 or 4 x beep
1 or 4 x
flash
possible
off
off
open
off
off
warning
warning
sensor
sensor x2
1 x beep
1 x flash
flash
not possible
not possible
short on
locked
locked
on
direct sensor
on
on
flash
not
possible
on
on
locked
off
off
Publicité
