Velleman-Kit K3512 Mode D'emploi page 3

REMOTE CONTROLLED CAR ALARM SYSTEM
This outstanding car alarm is full of potential, able to connect up with and operate a variety
of sensors. In addition, the remote control facility (infra red for K3512) allows the central
locking system to be operated together with the alarm.
CONSTRUCTION
A description of how the components supplied can be fitted now follows. For individual options
the manual for the option concerned should be consulted.
1. Construction of the main unit:
It is best to mount the main unit somewhere underneath the dashboard. Ensure that the
electric contacts are well within reach, so that the whole unit can be easily removed for
any servicing.
Use the stand-off nuts and bolts provided.
If the PCB is to be placed under the bonnet, then a watertight housing has to be used.
The PCB has been specially made to fit into our G313 housing, see photograph:
Note: for feeding the cables, make an opening to feed the cable loom through and
then seal it with silicone.
2. Fitting the LED indicator:
Mount the LED indicator in a prominent position, so that you, as well as any potential
intruders can see that a security system is in operation. Preferably place the LED above
the dashboard or on top of the centre of the facia panel. Drill an 8 mm hole and place
the LED in it. Feed the wires to the main unit.
3