Moving The Machine - Carat T-6010 Mode D'emploi

5. Moving the machine

The T-5010/T-6010 can be moved easily using the
transporting handles.
Before moving the machine ensure that:
- the sliding carriage is fixed in position by the
carriage lock;
- the motor head is completely lowered using
the locking lever;
- the legs are in the moving position (photo 9).
WARNING !
BEFORE MOVING THE LEGS, REMOVE THE
WORKING SURFACE HANDLE.
TO MOVE THE MACHINE USE A FOUR-PART
SLING, CONNECTED TO THE HOOKS IN THE
TRANSPORTING HANDLES (PHOTO 6).
6 6
6. Moving wheels kit
The machine can be moved by one person only,
using the "moving wheels" accessory.
WARNING !
IN ORDER NOT TO COMPROMISE THE STABILITY
OF THE MACHINE, FOLLOW THE INSTRUCTIONS
BELOW CAREFULLY. SUPPORT THE MACHINE
DURING INSTALLATION OF THE WHEELS KIT.
Starting from the working position, with the help of a
second person:
a) support the machine and slacken the lock on
the left leg (motor side)
b) lift the leg and insert it into the wheel support
(photo 7)
c) lock the leg in position using the leg lock
7 7
d) tighten the wheel support screws (photo 7)
e) repeat this operation on the right leg.
INFORMATION
TO FACILITATE
T-5010/T-6010 TO THE SITE, IT IS ADVISABLE
TO CARRY IT IN THE LOWERED POSITION.
a) slacken the leg locks on the front (working
surface side) one at a time, supporting the
machine by the transporting handles.
b) lower the rear of the machine by sliding the legs
into the supports until the middle hole of the
legs is aligned with that of the supports.
8 8
c) lock the legs in position using the relevant
clamps
d) repeat the operation indicated in points a), b)
and c) on the rear side (motor side).
31
GB
MOVEMENT OF THE