Evaluating Results - Beurer medical BC 58 Mode D'emploi

Correct posture
Measuring blood pressure
position.
STOP" button. After the full-screen display, the most re-
cently used user memory appears (
the user memory, press the "MEM" button and confirm
your selection with the "START/STOP" button. If no
button is pressed, the most recently used user memory is
automatically used after 5 seconds.
ly displayed. If there is no measurement in the memory,
the instrument always displays the value "0".
• • • • • • • • • • • • •
or ). To change
Wait at least 5 minutes before taking another measurement!

6. Evaluating results

-
Cardiac arrhythmia:
This instrument can identify possible cardiac arrhythmia
disorders during measurement and if necessary indicates
the measurement with the flashing icon
17
released slowly.
If a tendency towards high blood pressure is already
detectable, the cuff is pumped up again and cuff pressure
increased further. As soon as a heart rate is detected, the
heart rate symbol is displayed.
sing the "START/STOP" button or by pushing the touch
screen activation button to "OFF".
measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat
the measurement.
or push the touch screen activation switch to "OFF". If
you forget to switch off the device, it switches off auto-
matically after approx. 1 minute.
-
.