Wolf SEM-1 Instructions De Montage page 10

Solar tank SEM-1
Note
10
Technical Data .................................................................................................... 11
Pipework ............................................................................................................. 12
Installation / Assembly ........................................................................................ 13
Controller for charging pump ............................................................................. 14
Commissioning - Servicing ................................................................................. 15
Solar tank type SEM-1 made of steel S235JR with quality certification (with side flange).
Corrosion protection by double coat enamelling of the inner surface of the tank and heater
coil in accordance with DIN 4753, part 3. Additional corrosion protection with magnesium
protection anode. Can be used with all water conditions and in any pipe system.
By operating the tank below 60°C, substantial energy savings can be achieved.
Ideal operating temperatures are between 50-60°C.
Heat loss and calcification is substantially reduced in this range.
Solar tank type SEM-1
SEM-1
3043754_0310