Philips ErgoFit FC9269 Mode D'emploi page 13

using the filter-cleaning handle to clean the filter cylinder
(specific types only)
6
x
using the autoClean button to clean the filter cylinder (specific
types only)
Always press the AutoClean button when you have finished vacuum
cleaning.
Make sure the dust bucket, the filter cylinder and the filter cylinder case
are installed properly and the cover is closed properly.
,
,
,
using the autoClean button during vacuuming (specific types
only)
You can also press the AutoClean button during vacuum cleaning. When
you do this, the motor stops running and the filter-cleaning process starts.
During the filter-cleaning process, the appliance does not suck up dirt.
When the filter-cleaning process is finished, the motor automatically starts
running again and you can continue vacuum cleaning.
1 Switch off the appliance and unplug it.
2 Keep the appliance in horizontal position, with all wheels touching
the floor.
3 Press the cover release button (1) and open the cover (2).
4 Turn the filter-cleaning handle until it has made 6 full circles.
5 Close the cover firmly ('click').
1 Switch off the appliance. Leave the mains plug in the wall socket.
2 Keep the appliance in horizontal position, with all wheels touching
the floor.
3 Press the AutoClean button on the remote control on the handgrip.
You hear a beep and the filter-cleaning process starts.
During the filter-cleaning process, the appliance produces a rattling
noise. This is completely normal.
When the filter-cleaning process is finished, you hear a beep.
English
13