Pallmann GECKO STAR 2.0 Traduction Du Mode D'emploi Original page 27

6.3 Installation of the dust bag (G)
Caution!
Unintentional activation of the machine may present danger. The machine must be
switched off and the mains connector unplugged for all work on the machine.
Caution!
Use original FRANK dust bags exclusively for the GECKO STAR 2.0.
The dust bag must be installed firmly on the dust tube before sanding work commences.
Steps:
1. Pull the dust bag over the dustbag hanger (1).
2. Fasten the dust bag in place with the cord (2).
3. Fit the dust bag with the hanger onto the tube.
Check the dust bag prior to each commissioning.
Switch on the machine and check the dust bag for leaks and the
correct seating in the area of the dust tube connection.
6.4 Disposal of sanding dust / Emptying the dust bag
1. Remove loose dust by gently tapping on the dust bag.
2. Carefully open the draw cord on the dust bag and remove the bag.
Keep the dust bag opening closed.
3. Empty the dust bag outdoors into a non-flammable waste bin.
Caution! Risk of fire!
Because of the fire risk, the sanding dust contained in the dust bag must always be
disposed of immediately every time the machine stops or when sanding is completed.
The sanding dust must be disposed of in a fireproof, non-flammable container.
The container must be covered with a fireproof, non-flammable lid.
Store the container only outdoors.
Caution!
When a third of the dust bag is filled with sanding dust at the latest, empty the dust bag.
Otherwise, the dust absorption performance of the machine will deteriorate.
The sanding dust must be disposed of in a fireproof, non-flammable container.
The container must be covered with a fireproof, non-flammable lid.
Store the container only outdoors.
Caution!
Always wear a dust mask when disposing of the sanding dust.
A dust mask is supplied as accessory with the machine.
Seite 27 Gecko Star 2.0 12/2016