Pallmann GECKO STAR 2.0 Traduction Du Mode D'emploi Original page 26

6. Commissioning
Caution!
Danger of death due to current surge! Before start-up, check the power cable for
damage! Never operate the tool with a damaged power cable.
Caution!
Note the data on the type plate. Only use with the intended mains voltage and frequency.
Installation of the additional handle
6.1
1. Screw (1) the additional handle on at the rear of the machine. (D)
2. On the sanding attachment, a star knob (2) can be screwed
in for improved handling. (E)
Note!
The additional handle allows the machine to be much more easily guided into
inaccessible places. The additional handle is included as an accessory.
Caution!
Unintentional activation of the machine may present danger. In principle, the machine
must be switched off and the mains connector unplugged for all work on the machine.
6.2 Installation of the dust tube (F)
Note!
The GECKO STAR 2.0 is delivered with the dust tube dismantled.
Caution!
Unintentional activation of the machine may present danger. The machine must
be switched off and the mains connector unplugged for all work on the machine.
Note!
The dust tube has several drilled holes (2) at the end of the tube. The locking pin (1) latches into
these holes and prevent the dust tube turning and loosening.
The dust tube can be fastened in four positions with the locking stud (F)
Caution!
Ensure that the dust tube and the connection ports are dust-fee.
Seite 26 Gecko Star 2.0 12/2016