Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
17
18
19
20
21
18
Align the position of the rudderhorn and mark it
with felt-tipped pen.
Cut an opening at the mark in the rudder. Light-
ly sand the horn and glue it with epoxy.
Estimate the exact length of the pushrod at
neutral position of the rudder and servo.
Turn the clevis in or out to adjust the lenght of
the pushrod.
If everything is OK fasten the elevator with the
screws.
Close the servocover with tape.
Publicité
Table des Matières
