Cheetah Staufenbiel Instructions De Montage page 17

13
14
15
16
Enlarge the inner hole of the servo horn to
1,8mm.
Adjust the servo with the transmitter to neutral.
Install the horn and cut it according to the foto.
Connect the 50cm servo extension cable und
route it to the fuselage.
Glue the elevator servo in the fuselage. Estima-
te the lenght of the pushrod an bend them to
90°.
IMPORTANT: Please take care that there are
enough threads left at the clevis to adjust the
lenght.
EN
17