Tv 902 Navigator Switching Off; Emergency Stop - Agilent Technologies TV 902 Navigator Notice De Mode D'emploi

16 Instructions for Use
Use

TV 902 Navigator Switching off

To switch off the TV 902 Navigator it is necessary to remove the
mains. The integrated controller immediately stops the pump.
WARNING! The Turbo-V controller must be powered with 3-wire power cord (see
orderable parts table) and plug (internationally approved) for user's safety.
Use this power cord and plug in conjunction with a properly grounded power
socket to avoid electrical shock and to satisfy CE requirements. High voltage
developed in the controller can cause severe injury or death. Before servicing
the unit, disconnect the input power cable.

Emergency Stop

To immediately stop the TV 902 Navigator in an emergency condition
it is necessary to remove the supply cable from the mains plug.
234/276 TV 902 Navigator User Manual / 87-900-999-01 (B)