BH FITNESS G2487i Instructions De Montage Et Utilisation page 14

Fig.1 Parts list
(1) Monitor.
(4) Main post.
(20) Upper handlebar (left)
(25) Cover for left upper
handlebar(rear).
(29) Cover for left upper
handlebar(front).
(32) Upper handlebar (Right).
(33) Cover for right upper
handlebar(front).
(34) Cover for right upper
handlebar(rear)
(35) Handlebar stem.
(72) Main body.
(143) Bottle holder.
(146) Bracket cover.
(147) Focus bar spindle covers (L).
(148) Focus bar spindle covers (R).
(149) Covers main post left (L).
(150) Covers main post right (R).
(158) Transformer.
(174) Front frame.
Fig.2 Screws and fasteners
(3) Screws M-8x16.
(23) Screws M-4x40.
(51) Screws M-5x110.
(151) Allen screws M-8x55.
(152) Screws M-3x16.
(153) Self locking nuts M8.
(154) Washers M8 Ø 16.
(155) Washers M8 Ø 16.
Combination box spanner.
Allen key.
2. CHASSIS ASSEMBLY.-
Pass the cable (73) through the main
post (174) using the guide (178). Bring
the main post (174) up to the boss on
the main body (72) in the direction of
the arrow, Fig.3, making sure not to
snag any of the cables.
Drive the screws (175) together with
the washers (176) and washers (177)
and tighten securely.fig4.
FITTING THE MAIN POST.-
3.
Insert the left focus bar (20) onto the
focus bar spindle (10), Fig.5, then fit
the right focus bar (32) on the other
end of the spindle. Fit the bolts (13)
and the flat washers (12) and tighten
securely. Take the covers (33) (34),
and position them at the spindle end
with the bars on the right hand side,
as shown in Fig.5. Now use screws
and (23) (24) to attach them. Carry out
the same procedure at the other end
of the bar using the covers (25) (29)
marked on the inside with the letter
"L".
Be sure that the bushes (11) are in
the correct position. Fig 5.
Take the main post (4) and remove
the screws
washers (16) and spring washers (17)
from the bottom of the post. Fig.5.
Next, bring the main post (4) up to
boss on the main body (174), Fig.3,
connect the terminals (73) and (19),
Fig.5.
Slip the main post (4) over the boss
(D) on the main body (174) in the
direction of the arrow, Fig.5, making
sure not to snag any of the cables.
Refit the screws (15), the washers
(16) and the spring washers (17) that
you removed previously, and tighten
securely.
Next, position the side cover (149) and
(150) so that it faces the bottom
triangle on the main body (72) and
secure the cover using screws (75).
ATTENTION: It is advisable to
retighten these screws after one
month of using the machine.
14
(15) the corrugated