Makita SSP MTR051 Manuel D'instruction page 6

Templet guide
013208
The templet guide provides a sleeve through which the
bit passes, allowing use of the trimmer with templet
patterns.
1
2
3
4
013215
Loosen the clamping screw (A) and then remove the
guide holder and the chip deflector.
2
3
013209
Loosen the screws and remove the base protector.
Place the templet guide on the base and replace the
base protector. Then secure the base protector by
tightening the screws.
1
2
3
4
005435
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1. Clamping screw
6
(A)
2. Adjusting screw
3. Clamping screw
(B)
4. Trimmer guide
5. Chip deflector
6. Guide holder
5
1. Screwdriver
1
2. Base protector
3. Screws
3
1. Bit
5
2. Base
3. Templet
4. Workpiece
5. Templet guide
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the router bit and the outside of the
templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of the templet guide -
router bit diameter) / 2
Straight guide (optional accessory)
013210
The straight guide is effectively used for straight cuts
when chamfering or grooving.
1
2
3
4
001990
Attach the guide plate to the straight guide with the bolt
and the wing nut.
Remove the guide holder and the chip deflector.
4
3
013211
Attach the straight guide with the clamping screw (A).
Loosen the wing nut on the straight guide and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
6
1. Bolt
2. Guide plate
3. Straight guide
4. Wing nut
1. Clamping screw
(A)
1
2. Straight guide
3. Wing nut
2
4. Base