Installing Batteries - Insignia NS-S4000 Guide De L'utilisateur

Insignia NS-S4000 Clock Radio with iPod Dock
Connecting the AC power adapter
To connect the AC power adapter:
1 Plug the power cord into the DC jack on the back of your clock
radio with iPod dock.
2 Plug the other end of the AC power adapter into a 120V AC 60 Hz
power outlet.

Installing batteries

Note:
Warning:
To replace the battery in the remote control:
1 Slide and pull to release the battery cover latch.
2 Match the polarity on the lithium cell (CR2025-3V) with the plus
sign (+) on the battery tray.
3 Slide the tray with new battery into the battery compartment until it
clicks into place.
To replace the battery for the clock:
1 Open the battery compartment by pressing the small tab of the
battery cover.
Lithium coin batteries are installed in the remote control and the clock
radio with iPod dock at the factory.
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
Slide
www.insignia-products.com
Pull
+
C 2025 R
3V
13