Time And Date Adjustment; Rf Installation - Uponor BT Série Guide D'utilisation

2.2 Time and Date adjustment

Each time a value blinks, you can adjust it with the (-) and (+) keys, once
the value is chosen, validate it with the (OK) key. The thermostat will jump
automatically to the next value.
Note: you can always come back to the previous value by pressing the
escape key ( ).
List order of the time and date adjustments:
Time and day:
Adjustment of the hours,
Adjustment of the minutes
Adjustment of the day (1 = Monday)
Date:
Adjustment of the day number
Adjustment of the month number (01 to 12)
Adjustment of the year (Century)
Adjustment of the year
Then the message "Save" and blinking green LED appears, press (OK) to
validate the adjusted time and date.
You can always reach the time and date adjustments, by pressing and
maintaining the edition ( ) key during 2 seconds in normal operating modes.

2.3 RF installation

- First of all to configure your thermostat with the receiver, you must put
your receiver in « RF init ». mode. (please refer to the receiver leaflet for
this, only the RF receiver of the same range are compatibles)
- Now on the thermostat press and maintain the edition key ( ) during 10s,
then the parameter « ini » must be display.
The thermostat will send now the radio configuration signal to the receiver.
- On the receiver check the good reception (generally showed by a green
LED blinking). Once the configuration between the receiver and the
thermostat made, press on the escape key (
screen.
WIRELESS THERMOSTAT USER GUIDE
) to come back to the main
7