Troubleshooting & Solution - Uponor BT Série Guide D'utilisation

Troubleshooting & Solution
7
Batteries Problem
Problem on sensors
Batteries level is too
less
My BT DP-01 seems work correctly but the heating doesn't work correctly
Output
RF
communication
WIRELESS THERMOSTAT USER GUIDE
My BT DP-01 doesn't start
- Check if the protection sticker on the batteries is
removed.
- Check the batteries orientation.
- Check the capacity of the batteries
My BT DP-01 Led, blinks in Red
The logo blinks (ambient sensor)
- Contact your installer or seller.
The logo blinks (Floor sensor)
- Check the connection of the sensor.
- Disconnect the sensor, and check it with an
ohmmeter
(the value must be around 10kohms)
The logo blinks (Batteries)
- Replace the batteries.
On the receiver:
- check the good reception of RF signal
- Check the connections.
- Check the power supply of the heating element.
- Contact your installer.
- Check the following points :
- The receiver must be put at a minimum distance of
50cm of all others electrical or wireless materials
(GSM, Wi-Fi..)
- The receiver shouldn't be fixed on a metallic part
or too close of hydraulic pipes... (Copper...)
20