Uponor BT Série Guide D'utilisation page 18

To enter the value shown on the thermometer, use the (-) or (+)
keys to enter the real value. Then, press (Ok) to confirm.
The message "Yes" should be displayed; the value will be stored in
the internal memory.
If you need to erase a calibration press on the escape key (
The old value will be erased and the message "no" will be displayed.
* Pay attention:
Only the heating element driven by the thermostat must be used
during the complete step of the calibration.
05 OutC , AMbC , FlrC: Calibration of the external wired probe
Same calibration method as described in parameter
"04 AirC" above.
06 HG: Anti-freeze temperature used in Holiday mode
Default value 10°C.
Use the (-) or (+) keys to change the anti-freeze setting
temperature. Then press (Ok) to confirm.
07 ITCS: YES, no
The Intelligent Temperature Control System will activate your
installation in advance (2 hours maximum) to assure the desired
temperature at the hour programmed following your weekly program.
This automatic control system works in the following way:
When you start your thermostat for the first time, it will measure the
time taken by your installation to reach the set temperature. The
thermostat will re-measure this time at each program change to
compensate external temperature change & influence. You can now
program your thermostat without the need to adjust the temperature
in advance because your thermostat does it automatically for you.
08 Clr ALL: Reset to Factory setting
Press and maintain (Ok) key during 10s to reset Set points
temperatures and user parameters in this menu to factory default
settings. User programs will also be resetted.
Pay attention:
Ensure you that you have all necessary elements to re-setup your
installation before to use this function.
09 Software version
VErS ___
10 End: Exit the parameter's menu
Press (OK) key to exit installation parameter menu and return to
normal operation.
WIRELESS THERMOSTAT USER GUIDE
18
).