Bergstrom Integral power II Instructions De Montage page 20

INTEGRAL POWER II
EN
Attach the EPDM seal around the hatch gap
3
(see the details to cut the ends of the seal
joint).
HOW TO CUT THE EPDM SEAL TO PREVENT
!
WATER FROM DRIPPING IN THE CABIN
A- Attach the seal, keeping 100 mm of
protection paper on each side.
B- Remove the two pieces of paper.
C- Attach by pressing both ends.
B
Seal
Important: The Integral Power II has 4 plates
!
welded to the sides of the base in order to
ensure safe lifting using mechanical lifting
equipment.
Seal
Remove
3
A
Seal
100 mm approx. (protection paper)
C
Seal
20
15 mm
Seal
Cabin roof
Seal