LaserLiner SensoMaster 400 Mode D'emploi page 36

SensoMaster 400
ROD CLAMP
a
b
a. Captive Rod Clamp Screw - attaches to the back of detector.
b. Alignment Points (2x) - help secure and align rod clamp.
c. Clamping Screw Knob - secures clamp to rods by moving the traveling jaw.
Clockwise tightens; Counterclockwise loosens.
d. Reference Bar - top of bar is aligned with the detector's on-grade location for
both standard center on-grade and offset on-grade clamp locations.
e. Traveling Jaw - moving jaw grips tightly to rods.
f. Reversible Face - slanted face is used to tightly grip round and oval rods; flat face
is used to grip rectangular and square rods.
g. Flathead Screw - holds reversible face in place. Remove with flathead screwdriver.
Rotate face as shown to change.
36
f
e
d
c
ENGLISH
f
Rectangular Oval / Round
Rods
g
Rods