ARTHUR MARTIN AW6T7242AF Notice D'utilisation page 17

• Position A for powder detergent (factory setting).
• Position B for liquid detergent.
When you use the liquid detergent:
• Do not use gelatinous or thick liquid detergents.
• Do not put more liquid then the maximum level.
Setting a programme
1. Turn the programme dial to select the
desired washing programme.
The indicator of the Start/Pause
flashes.
The display shows an indicative
programme duration.
2. To change the temperature and/or the
spin speed, touch the related buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds and
the display shows
Starting a programme
Touch the Start/Pause
the programme. It is not possible to start
the programme when the indicator of the
button is off and doesn't flash (e.g.
programme dial on a wrong position).
The related indicator stops flashing and
stays on.
The programme starts, the lid is locked.
The display shows the indicator
The drain pump can operate
shortly before the appliance fills
water.
Starting a programme with the
delay start
1. Touch the Delay Start
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
button
.
button to start
.
button
.
2. Touch the Start/Pause
appliance lid locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows
and the indicator
3. Touch the Start/Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
again to start the new countdown.
The SensiCare System load
detection
After touching the Start/Pause
1. The SensiCare System starts
estimating the weight of the load to
17
button. The
.
button to
button
goes off.
button
button to
button
button
button: