I - Introduction; Warnings - ACteon Mini Led III SuperCharged Manuel D'utilisation

MLED III Supercharged U7
I – INTRODUCTION
You have just taken possession of your Mini LED
SuperCharged unit, congratulations.
Created by SATELEC®, the Mini LED SuperCharged is a
photopolymerizer allowing dental care to be given using
the suitable light guide supplied with the unit.
To take full advantage of the technology of this product,
we request that you read carefully the chapter covering
all safety recommendations.
The manufacturer's warranty is applicable only if these
indications relating to the unit's operation and safety
have been correctly applied. All of these safety
measures require a sound knowledge of dentistry,
photopolymerization and of the specific instructions
regarding the operation of the Mini LED SuperCharged
given in this operating manual.
Sections with the symbol are
would like to attract your attention.
II – WARNINGS
United States Federal Law restricts on its
territory the use of this unit exclusively to trained,
capable and qualified dental healthcare professionals,
or under their control.
To reduce the risk of accidents, it is imperative to
comply with the following precautions:
Users of the unit
Use of the Mini LED SuperCharged is limited exclusively
to trained dental healthcare professionals, apt and
qualified in the usual context of their activity.
If you have received this unit in error, contact the unit's
supplier to arrange for its return.
Interactions/contraindications
Do not use on persons currently suffering from, or that
have suffered from in the past, photo-biological
reactions (including solar urticaria or erythropoietic
protoporphyria) or on persons undergoing treatment
using photosensitizing
methoxsalen or chlortetracycline).
Any person, practitioners or patients who have
previously suffered from a retina or lens condition or
who have undergone eye surgery, in particular cataract
surgery, must consult their ophthalmologist before using
this unit.
Even in the event of agreement, it is strongly
recommended to be prudent as the light intensity may
V6:Mise en page 1
points to which we
medications (including
6
05/09/2011 09:53 Page 6
cause accidents.
It is particularly recommended to continuously
wear protective glasses suited to the use of
equipment emitting radiation of wavelengths less than
500 nm.
The light radiation produced by this type of equipment
can be dangerous and must never be directed towards
the eyes, even if the practitioner or the patient is
wearing protective glasses suited to the use of
equipment emitting radiation of wavelengths less than
500 nm.
The lighting produced by this lamp must be directed
only at the part to be treated in the oral cavity.
Interference may occur when used on patients
with cardiac pacemakers. This system emits
electromagnetic fields, which means there are some
potential risks. The malfunctioning of implantable
devices such as cardiac pacemakers and ICDs -
implantable cardioverter defibrillator (in general, any
type of active implant) is possible:
- Ask patients and users if they have an implanted
device before using this product. Explain the
circumstances to them
- Weigh the risks and benefits and contact your
patient's cardiologist or appropriate qualified
healthcare professional prior to performing the
treatment
- Keep this product away from implanted devices
- Make appropriate emergency provisions and take
immediate action if patients become ill
- Symptom including a raised heartbeat, irregular pulse,
and dizziness may signal problems with a cardiac
pacemaker or ICD.
The unit complies with current electromagnetic
compatibility standards, nevertheless, the user shall
ensure that any electromagnetic interference does not
create an additional risk (presence of radiofrequency
emitters, electronic equipment...).
Overexposure to light radiation of the pulp and
soft tissues can result in the release of heat and can
result in injury to the patient.
To use your equipment in the best possible
conditions, it is important to comply with the
specifications given in sections II - WARNINGS
Equipment users and V – ROUTINE USE.
As far as possible, avoid the accumulation of heat due
to a dental dam.
To avoid a sensation of heat, it is recommended to
separate cycles by 10 seconds for polymerization
times of 10 seconds or less, and by 30 seconds for