Metal Cutting; Dust Extraction - Makita JV103D Manuel D'instruction

Finishing edges
To trim edges or make dimensional adjustments, run the
jig saw blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant jig saw
blade wear. The underside of the workpiece can be
greased instead of using a coolant.

Dust extraction

Clean cutting operations can be performed by connect-
ing this tool to a Makita vacuum cleaner.
Installing or removing the dust cover
Install the dust cover as shown in the figure.
► 1 . Dust cover
To remove the dust cover, press one side of the cover,
and then remove it as shown in the figure.
1
► 1 . Dust cover
Installing or removing the dust
nozzle
Insert the dust nozzle all the way into the tool.
1
► 1 . Dust nozzle
To remove the dust nozzle, pull out the dust nozzle
while pressing the button on the dust nozzle.
10 ENGLISH
1