Care And Maintenance - Olsberg 14/512-3 Notice D'utilisation

Care and Maintenance

• Olsberg heaters have been constructed so that
they need only a minimum of maintenance.
• OLSBERG Standard heaters are fitted with a fluff
filter. The fluff filter should be cleaned at regular in-
tervals, dependent on the amount of dust in the
room (ideally before each heating season).
Cleaning the filter should only take place on a cold
heater (operating knob at full anti-clockwise posi-
tion). Push the air-outlet grille to the left. The fluff
filter can now be removed and cleaned or replaced
by a new one (see chapter „Spare filter set", page
35).
Caution: The fluff filter must be completely dry be-
fore it is reinstalled into the heater.
• The fan is equipped with self-lubricating bearings.
We recommend that the heater be opened from
time to time by a qualified installer who can free
the heater from any dust which may have accumu-
lated on the fan or in the air-outlet channels.
• Cleaning and maintenance intervals are dependent
on the conditions under which the heater works.
We recommend that the first check take place at
the latest before the beginning of the second heat-
ing period. Further maintenance intervals can then
be individually set.
• We recommend that the control and regulation
elements of the heater also be checked regularly.
All safety, control and regulation elements should
be checked by a qualified installer at the latest 10
years after initial installation. This can save unnec-
essary energy costs.
• Do not use soft-scrub or other abrasive substances
to clean the surfaces of the heater. Normal house-
hold cleaners suffice entirely.
34
Fig.6 Fluff filter