Olsberg Standard Heater - Olsberg 14/512-3 Notice D'utilisation

OLSBERG Standard heater

14/512 14/513
3
14/514 14/515
4
2
5
1
14/516 14/517
1
Opening the heater:
1. Prise off the plastic caps and remove the
screws.
2. Lift the top panel approx. 10mm.
3. Pull the top panel forward and out.
4. Pull the rear top panel forward and out.
5. Take hold of the side panels at the front and
jerk outwards.
Note:
The side panel can be removed from the
heater without taking off the top cover panel.
Prise off the right-hand plastic cover cap and
remove the screw, push the air-outlet grille to
the left, thread the tip of a screwdriver on to
the top edge of the fluff filter and push the
right hand side panel outwards.
Remove the top insulation, packaging and as-
sembly material. For reasons of safety against
breakage, the cover panel insulating mats are
laid inside the heater, upright against the front
panel insulation during transport.
2
Place the heater in its final position. Align the
tilting safety screw in its final position on the right
or left hand inner panel and fix it firmly to the wall.
25