Floor-Standing Consoles (Accessory) - Olsberg 14/512-3 Notice D'utilisation

Floor-standing Consoles (Accessory)

Fig.3
24
When mounting the heater to the consoles, these
should be fixed both to the wall and the floor at spac-
ing "D" in Fig.3 using suitable fixing materials (9mm
holes in the floor-standing consoles).
Place the heater with its feet on the consoles.
Screw the heater firmly to the console using the
L-brackets 40x30mm and M6x16 hexagonal-head
bolts, washers, star washers and nuts M6 supplied.
The bolts should be threaded through the heater from
inside to out (Detail E)
Make sure that the fixing bracket is tight to the under-
side of the heater and to the consoles.
Heater Dim. A
14/512 575
14/513 750
14/514 925
14/515 1135
14/516 1310
14/517 1310
Dim. D Dim. E
275 124
450 124
625 124
870 89
1045 89
1045 89