Sony HMM-3000MT Instructions D'utilisation page 15

Recommended separation distances between portable and mobile RF communications equipment and the
The HMM-3000MT is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of the HMM-3000MT can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment (Transmitters) and the HMM-3000MT as
recommended below, according to the maximum output power of the communications equipment.
Rated maximum output power of transmitter
W
0.01
0.1
1
10
100
For transmitters rated a maximum output power not listed above, the recommended separation distance d in meters (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating
of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
Caution
When you dispose of the unit or accessories, you must
obey the laws in the relative area or country and the
regulations in the relative hospital.
For the customers in Europe
This product has been manufactured by or on behalf of
Sony Corporation, 1-7-1 Konan Minato-ku Tokyo,
108-0075 Japan. Inquiries related to product compliance
based on European Union legislation shall be addressed to
the authorized representative, Sony Deutschland GmbH,
Hedelfinger Strasse 61, 70327 Stuttgart, Germany. For any
service or guarantee matters, please refer to the addresses
provided in the separate service or guarantee documents.
Caution
This unit is not fitted with a drop prevention strap or other
restraining device to reduce discomfort when mounting the
unit.
When mounting the unit or detaching the unit, take care
not to drop the unit.
If the unit is dropped and becomes damaged or operates
abnormally, cease operating the unit and request repair
from your Sony service representative.
Caution
For details about menu operations, refer to the HMI-
3000MT operating instructions.
HMM-3000MT
Separation distance according to frequency of transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz
d = 1.2 √P
0.12
0.38
1.2
3.8
12
Caution
Use only the dedicated HMO-CA50M connection cable to
connect the HMI-3000MT and HMM-3000MT.
The use of a different cable or extension cable may cause
the unit to operate incorrectly.
For the customers in the U.S.A.
SONY LIMITED WARRANTY - Please visit
http://www.sony.com/psa/warranty for important
information and complete terms and conditions of
Sony's limited warranty applicable to this product.
For the customers in Canada
SONY LIMITED WARRANTY - Please visit
http://www.sonybiz.ca/solutions/Support.do for important
information and complete terms and conditions of Sony's
limited warranty applicable to this product.
For the customers in Europe
Sony Professional Solutions Europe - Standard Warranty
and Exceptions on Standard Warranty.
Please visit http://www.pro.sony.eu/warranty for
important information and complete terms and
conditions.
For the customers in Korea
SONY LIMITED WARRANTY - Please visit
http://bpeng.sony.co.kr/handler/BPAS-Start for
important information and complete terms and
conditions of Sony's limited warranty applicable to this
product.
m
800 MHz to 2.5 GHz
d = 1.2 √P d = 2.3 √P
0.12
0.38
1.2
3.8
12
0.23
0.73
2.3
7.3
23
15