Electrical Connection - DeLonghi EL290 Série Mode D'emploi

INTRODUCTION
Than you for choosing a De'Longhi product. Please ta e a few
moments to read the instructions to avoid ris s or damage to the
appliance.
DESCRIPTION
Description of the appliance (See page 3 - A)
A1 Air outlet flap
A2 Control panel
A3 Handles
A4 Wheels
A5 Remote control signal receiver
A6 Remote control storage
A7 Filter
A8 Air inta e grille
A9 Air exhaust hose housing
A10 Air inta e grille
A11 Drainage hose with cap
A12 Power supply cable
Description of accessories (See page 3 - B)
B1 Wall flange with cap
B2 Air exhaust hose
B3 Window outlet
B4 Window brac et with pins
B5 Additional window brac et with pins
B6 Water drain hose with cap
B7 Remote control
B8 End of season dust cover
B9 End of season accessories bag

Electrical connection

Before plugging the appliance into the outlet, chec that:
• The outlet's power supply corresponds to the value
indicated on the rating label on the bac of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• The outlet is a 3-hole grounded outlet
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a quali ed professional only.
The instructions below will enable you to prepare your air
conditioner for operation as e ciently as possible. Before use,
ma e sure the air inta e and outlet grilles are unobstructed.
USE
Note: This appliance features an auto evaporative
function to remove excess condensate water
during cooling and dehumidi ying modes.
CONDITIONING WITH INSTALLATION
For optimal results set-up your appliance in this way:
• Fit the assembled air exhaust hose B2 in the housing at the
bac of the appliance. Insert it as shown in figure 1.
1
• Respect the distances given in figure 2.
. If this is not
min. 11.8 in
min. 30 cm
2
Proceed as follows:
• Drill a hole 5,25 inches (134 mm) in an outside wall or
through a wooden ic board. Respect the dimensions and
height of the hole given in figure 3 and 4.
5
min. 11.8 in
min. 30 cm