Fan Speed Setting; Timer; Emergency Operation For Wireless Remote-Controller - Mitsubishi Electric Mr.SLIM SEZ-KD25VAL Manuel D'utilisation

3. Operation

3.5. Fan speed setting

I Press the Fan Speed button 1 as many times as necessary while the
system is running.
• Each press changes the force. The currently selected speed is shown
at A.
• The change sequence, and the available settings, are as follows.
ON/OFF
1
MODE
CHECK
TEST RUN
SET
1 Press FAN
button to select a desired fan speed.
• Each time you press the button, available options change with the
display A on the remote controller, as shown next.

4. Timer

4.1. For wireless remote controller
ON/OFF
FAN
MODE VANE
CHECK LOUVER
TEST RUN
SET RESET
AAA

5. Emergency Operation for Wireless Remote-controller

ON/OFF
HEAT
A
TEMP
FAN AUTO STOP
VANE AUTO START
LOUVER h
min
RESET CLOCK
AAA
AAA
C
D
B
A
TEMP
AUTO STOP
13
AUTO START
h
2
min
CLOCK
AAA
1
2
COOL
Remote controller display
Fan speed
(Auto) Low
4-stage
( )
3-stage
( )
2-stage
( )
The wind speeds that can be selected depend on the model.
Note that some units do not provide an "Auto" setting.
The display and the fan speed of the unit will differ in the following situ-
ations:
• When the unit is in STAND BY mode or in DEFROST mode.
• Just after the heating mode (while waiting to change to another mode).
• When the temperature of the room is higher than the temperature
setting of the unit operating in the heating mode.
• In the dry operation, the indoor fan automatically turns to low-speed
operation. Switching of fan speed is impossible.
3.6. Ventillation
s s s s s For LOSSNAY combination
3.6.1. For Wireless Remote-controller
G The ventillator will automatically operate when the indoor unit turns on.
G No indication on the wireless remote controller.
1) Set the current time
1 Press the CLOCK button using a thin stick and blink the time A.
h min
2 Press the
and button to set the current time.
3 Press the CLOCK button using a thin stick.
2) Set the time to start the unit as follows
1 Press the AUTO START
button.
• Time can be set while the following symbol is blinking.
On time: B START is blinking.
• The start times is displayed at A.
h min
2 Use the and buttons to set the desired time.
3 To cancel the ON timer, press the
3) Set the time to stop the unit as follows
1 Press the AUTO STOP button.
• Time can be set while the following symbol is blinking.
Off time: C STOP is blinking.
• The stop times is displayed at D.
2 Use the h min
and buttons to set the desired time.
3 To cancel the OFF timer, press the
4) Changing the set times
Press the AUTO START or AUTO STOP to cancel the timer and repeat from 2) or 3).
1 ON/OFF lamp (lit when unit is operating; unlit when unit is not operat-
ing)
2 Emergency operation
In cases where the remote control unit does not operate properly, use
either the COOL or HEAT button on the wireless remote control
signal receiver to toggle the unit on or off. On cooler only units, pushing
the HEAT button toggles the fan on and off.
Pressing the COOL or HEAT button selects the following settings.
Operation mode
24 °C/75 °F
Preset temperature
Fan speed
Middle 2 Middle 1 High
(Middle)
AUTO START button.
AUTO STOP button.
COOL HEAT
24 °C/75 °F
High High
5