Troubleshooting - Sonoro MEISTERSTÜCK SO-610 Mode D'emploi

20

Troubleshooting

Malfunctions can occur with any electrical equipment. This is not
necessarily due to MEISTERSTÜCK defect. As such, you should
check the following table to see if you can eliminate the problem
yourself.
Malfunction
No power
No response from
MEISTERSTÜCK
Remote control does
not work, or only
works sporadically
No sound or poor
sound
© sonoro audio GmbH 2017
Possible cause
Power cable is not
properly connected.
There is an error in
MEISTERSTÜCK.
Distance to
MEISTERSTÜCK is too
large.
Battery is empty.
Sound is turned off.
MEISTERSTÜCK is not
set to the correct
playback mode.
Headset is plugged
in.
FM/DAB or Internet
reception is poor.
There is radio
interference.
Optical Input no
sound
Solution
Connect the power
cable properly.
Disconnect and
reconnect the power
plug. Then turn
MEISTERSTÜCK on
again.
Reduce the distance
between the remote
control and
MEISTERSTÜCK.
Replace the battery.
Adjust the volume.
Select another
playback mode.
Pull the headset out of
the jack.
Extend/adjust the
FM/DAB antenna or
check the Wi-Fi
connection.
Keep MEISTERSTÜCK
away from other
electronic devices.
Select PCM as output
source in the external
device.
109