Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Beta
OPERATION MANUAL AND INSTRUCTIONS FOR SILICONE AND SEALANT GUN
CAUTION
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE PNEUMATIC TOOL.
FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND OPERATING INSTRUCTIONS MAY
RESULT IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
–
The air silicone and sealant gun can be used for the following purposes:
• applying silicone and sealants
• the gun can also be used in open places exposed to water and air
–
The air silicone and sealant gun must not be used for the following purposes:
• the air silicone and sealant gun must not be used in environments containing potentially explosive atmospheres
• the trigger must not be locked with adhesive tape or clamps
• the air silicone and sealant gun must not be used with loose materials
• the air silicone and sealant gun must not be used for any applications other than stated ones.
WORK AREA SAFETY
–
Beware of both surfaces that may become slippery due to the use of the machine and the danger of tripping over the air hose.
–
While using the pneumatic tool for jobs performed high from the ground, take all necessary precautions, to eliminate or minimize
risk to other workers, following the accidental falling of any tools (for example, isolation of the work area).
Do not operate the pneumatic tool in environments containing potentially explosive atmospheres, because sparks may be
generated, which can ignite the dust or fumes.
Avoid contact with live equipment, because the pneumatic tool is not insulated, and contact with live parts can cause electric
shocks.
Keep children and bystanders away from your workplace while operating the pneumatic tool. Distractions from other people can
cause you to lose control over the pneumatic tool.
PNEUMATIC TOOL SAFETY
–
Do not point the air flow to yourself or other people. Compressed air can cause serious injury.
–
Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications in terms
of pressure and air volume. Too low pressure impairs the function of the pneumatic tool; too high pressure can cause damage
and/or injury.
–
Do not bend or tighten any hoses. Avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating parts.
Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed air pipe.
Raised dust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
PERSONNEL SAFETY
–
Stay alert; watch what you are doing. Do not use the pneumatic tool while tired or under the influence of drugs, alcohol, or
medication.
–
Always use the following personal protective equipment:
• eye protection;
• hearing protection;
• safety shoes;
• protective gloves against physical agents.
–
Make sure you are in a safe position, keeping proper balance at all times. A safe working position and a proper body posture
enable better control of the pneumatic tool in unexpected situations.
–
Do not directly inhale the exhaust air, and prevent it from getting into your eyes. The exhaust air of the pneumatic tool can contain
water, oil, metal particles and impurities, which may cause hazards.
MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
Publicité
Table des Matières
